For NASAs exploration beyond Low Earth Orbit (LEO), a Distributed Spacecraft Mission (DSM) model would distribute sensors, on board processing, mass storage and downlink communications to different smaller physical satellites. Within this DSM format the wired bus must be replaced by a wireless cross-link communication system that provides seamless connectivity between the individual modules at data rates similar to those available on the networks within a single satellite system. Aeronix proposes an innovative, value centric contribution to develop a cross-link communication subsystem with two-way ranging built in to the physical layer by leveraging existing Aeronix Nano COTS Software Defined Radio (SDR) and open-source technologies, along with previous work on distributed satellite communication from the DARPA F6 distributed satellite program. The communication and ranging subsystem will provide connectivity across modules using existing open source network software and COTS hardware, incorporating NASAs delay/disruption tolerant networking (DTN) standards, as well as providing automatically updated ranging data between mesh nodes. Externally the radio will appear as a managed switch to the module applications. The results of the Phase I effort are expected to be a conceptual design of the communication and ranging subsystem, with expected link and ranging performance characteristics, and realistic mass, size, weight and power estimates. Potential NASA Applications The communication with built-in ranging technologies could be used by NASA for other applications where communication between multiple independent vehicles is needed, especially in harsh environments. An example would be in communications between multiple independent rovers on the Moon or Mars. Potential Non-NASA Applications Applications for robust miniature communication systems exist within NASA, the DoD and the commercial markets. The target of this research is for small satellite use, however, the ability to provide this capability in a very low size, weight and power form factor is also applicable to multiple UAV based applications. The distributed node communication and ranging mesh concept also has application for use in location determination between vehicles in GPS denied areas.
